How to Adjust the Spring Tension of A Hose Reel?

The tension of the spring on a reel is normally adjusted at the factory. However, over time, the spring loses its tension or accumulates too much tension. Too much tension can cause premature wear of the reel or even breakage, while too little tension can prevent the hose from being held in the reel when not in use. Therefore, we should learn how to adjust the spring tension of a hose reel ourselves.

 

Step 1: Remove the positioning block
Step 2: Rotate clockwise / Wind it up
Step 3: Re-install the positioning block

 

So I’m going to tell you about this hose reel. It means that the elasticity is not enough. How to replace it? How to repair it? Because we sometimes use it. That’s the actual operation. It may have taken a long time. The spring’s mainspring, uh, there will be some uh. It’s just not elastic enough. Then here I will teach you how to deal with it. First, we snap this into place. Then remove the positioning block. And we follow the direction of this arrow. Rotate the hose reel clockwise. Wind it up! In this case, we will snap this part into position. Get stuck and go through this hose. Then install this positioning block. That’s ok.